I have also tried to award binocular obstacle avoidance on the machine arm, but binocular obstacle avoidance needs absolute level, so the actual measurement is not good either.
Yes... the stability will be affected, and the deformation rate on the arm is high, and it is also done with the rotating shaft. Later maintenance is a big problem. It is a design made for design...
Come on! As a designer, I have experienced the process from scratch.. After the design is completed, there is only a sense of accomplishment and happiness!
The binocular camera for obstacle avoidance requires accurate positional relationship. Otherwise, it is uncertain.
Handsome!
When designing, it is rare to be humble, not impetuous and pompous. Encourage each other
Difficulties and Pain Points, Stability and Balance of UAV
I like your work very much.
Do you accept internships?
Dajiang, a real "China-created" enterprise, praise one!
Is this already out-feeling that the market has seen something similar?
I have also tried to award binocular obstacle avoidance on the machine arm, but binocular obstacle avoidance needs absolute level, so the actual measurement is not good either.
Hao Ge!!
Come on! As a designer, I have experienced the process from scratch.. After the design is completed, there is only a sense of accomplishment and happiness!
Not bad! ~
It's quite good, but the picture is not big and not very high definition.
Indeed as expected is to design a project, can grow a lot, top landlord!
I just read a drone evaluation article in Puxiang..