All nonsense, kilogram is weight, what weight means, material cost, and processing cost are two different things. For sheet metal products, common processes include bending, blanking, stamping, stretching, etc. If you think about it, you will know that for a sheet metal, if you don't open the mold, too complicated or too large arc process will inevitably be troublesome.
The price of sheet metal on our side is calculated by weight. I am Party A. What should I do if I want to do the processing? Party B has to use how many arc knife molds to buy honestly. If I don't buy a knife, I can't pass the quality control. If I don't want to bear the cost, I will replace it. We do the design is to control the macro concept, the downstream how to do not interfere, only look at the results.
In fact, many designers do not know anything about the process, so they do the design and feel that they should be done when they design it. The design is a comprehensive consideration, including beauty, function, strength, cost and manufacturability.
It will cost a lot of money to get this out, and the cost is much higher than the original. Good things cost money. Hey. It's nice and it doesn't cost money. It's hard.
Our boss asked me to design the scheme, which requires a lower cost than a pure square box and simple, and the internal circuit board has not been changed. What do you say I should do.... Do I go to the supplier to reduce costs
What kind of software interface is this
What software can do this effect! Want to learn
The processing is too difficult and there are too many arcs.
It will cost a lot of money to get this out, and the cost is much higher than the original. Good things cost money. Hey. It's nice and it doesn't cost money. It's hard.
This is very modern industry.
It seems different from the one who took the photo.